Pigeon Wire Triangular Ridge Bracket - Stainless Steel PestFix

Features & Benefits: Pigeon Wire Triangular Ridge Bracket - Stainless Steel, Stainless Steel Ridge Bracket for mounting pigeon wire over ridge lines, 3 x 4mm X 90mm Posts, Supports three parallel runs of pigeon wire, Prevents pigeons from fouling ridges by placing wire where they want to land, 110mm X 4mm single head posts, use one bracket every 1.5m, Can be screwed down or glued using Fix AllWhere to Use:For Use in protecting triangular roof ridges from perching feral pigeons and preventing the roof from being affected by bird droppings.Use as a low-profile alternative to bird spikes on low pressure bird infestations.How to Install:, Brackets can be fixed to ridges in two different ways. Bonding, preferred method, strongest (remove legs), Mechanical Fix using screws in the holes provided, (remove legs) requires drilling of the ridge tile The bonding method is ideal for fragile tiles that do not take kindly to drilling. Ensure ridge tile is clean and dry and has been primed with adhesive prior to fitting bracket. Ensure that the bracket has been de-greased on the underside using surface activator. Leave for 24 hours to fully cure before wiring. Install brackets at no more than 1.5m centres, Install counter tension wires and screw pin anchor at each end of the ridge line without springs., Run wires, stopping and starting at each bracket with a crimp and spring (do not run wires through the bracket), Ensure wires are under load from the springs, but do not over-stretch the spring, leave some spring travel for when birds attempt to land.. Pigeon Wire Triangular Ridge Bracket - Stainless Steel PestFix